Place the v shaped end of the nail puller up to the nail and tap with a hammer to wedge it tightly under the nail head.
Best way to pull out nails from steel siding.
Pry bars would dent the.
Disclaimer our videos are for entertainment purposes only.
Pretty simple you have to break out the fc board and use a thin pry bar to knock off all the fc around the nail.
It is recommended that you.
Then just drive them in by slipping the small crow bar over the head and hitting the crow bar just short of the bottom of the siding covering the nail.
It was installed with ring shank nails.
The force of the hammer is usually enough to.
Place the claw securely around the nail you want to pull.
The best way to do that is to pound the pointed jaws of a cat s paw under the head.
The job was to remove the metal siding without damaging it and reuse it for another building.
Use a straight claw hammer or flat bar to remove the nails.
Step 4 push the handle of the hammer or nail puller down to lift and free the nail.
Drive a screw into the same board and the screw is pulling the wood fibers upward.
Slide your zip tool back and forth parallel to the section of steel siding that you have chosen.
Use a straight claw hammer or flar bar to pull the nails.
The nail should only be about an inch above the bottom of the upper piece.
As the board tries to return to equilibrium the nail is forced out by the wood fibers the screw is pulled tighter.
The head should be visible on the side of the claw that faces you.
To pull each nail you first need to raise the head a small amount.
Bend it downward so it s more accessible and.
You should be able to grip the nail with the zip tool.
Reach under the board with a pair of needle nose pliers and grip a shank.
Drive a nail into a board and it is deforming the wood fibers downward.